r Connecting terminals
1 2 3 4 5
6 7 8
9
10
1 <COMPUTER 2 IN/1 OUT> terminal
This is the terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals.
It can also output the signals input from <COMPUTER 1 IN>
terminal to an external device.
2 <COMPUTER 1 IN> terminal
This is the terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals.
3 <HDMI 1 IN> terminal / <HDMI 2 IN> terminal
These are the terminals to input HDMI signal.
4 <DC OUT> terminal
This is the USB terminal only used for power supply (DC 5 V,
maximum 2 A).
This can be used when a power is needed to be supplied to a
wireless display adaptor, etc.
5 <LAN> terminal
This is the LAN terminal to connect to the network.
6 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control the
projector by connecting a computer.
7 <VIDEO IN> terminal
This is the terminal to input video signals.
This is the terminal to input audio signals.
Left input <L> and right input <R> are provided for the <AUDIO
IN 3> terminal.
9
<AUDIO IN 1> terminal / <AUDIO IN 2> terminal
These are the terminals to input audio signals.
10 <VARIABLE AUDIO OUT> terminal
This is the terminal to output the input audio signal.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
22 - ENGLISH
Chapter 1 Preparation - About your projector
To Next Page
Loading...
