Panasonic PV-A208 - Copying your Tapes (dubbing); Main Operation

Copying your
Tapes (dubbing)
Main
Operation
Source
(Playing)
Camcorder
Audio/Video Cable
(supplied)
Monitor with
your
TV
•
Turn the TV ON
and
select
its VCR
channel (CH3 or
CH4).
•
Set the VCR/TV
Selector
on the
recording VCR to
VCR.
Before
you
begin...
•
Connect
the
Camcorder
to
VCR
as
shown
below.
•
Turn ON
both
units.
•
Set the recording VCR's
Input
Signal
Selector
to
LINE.
•
Set
the
Camcorder POWER
switch to
VCR.
Insert
a
pre-recorded tape
into the Camcorder
and a blank
tape
with a
recording
tab into
your
VCR.
Press
PLAY on the Camcorder
and
when
you
find the
starting
point,
press
STILL.
Press
REC
on your
VCR
and then
immediately press STILL/PAUSE.
VCR Buttons
PAUSE/SHU. STOP REW PLAY
Press STILL on the Camcorder
and
press STILL/PAUSE on the VCR
to
simultaneously
start both
units.
Press STOP on both
units
when
dubbing
is complete.
Note:
•
Tapes recorded on
other
VCRs
and
used
for
playback
in
the
Camcorder
must be recorded
in
SP
or SLP
mode.
•
For technical reasons, dubbing
a tape
may reduce its
quality.
*
CAUTION:
.
Unauthorized exchanging
and/or
copying
of
copyrighted recordings
may
be
copyright
infringement.
37