Panasonic PV-A208 - AC Adaptor

Supplying
Power
—
DC Power Cable
POWER
Lamp
DC IN
Connector
VCR
DC OUT Connector
Connect VCR DC OUT on
the
AC
Adaptor
to
DC
IN on
the
Camcorder with the
DC
Power
Cable
(supplied).
Plug
in
the AC Adaptor.
The POWER
Lamp will light.
Notes:
•
AC Adaptor cannot be
used
to power the Camcorder while charging
the Battery.
•
While
not in
use,
unplug
the
AC
Adaptor
from
the
AC
outlet. {When
plugged into an AC outlet, the
AC Adaptor
consumes 1 .2W of
electric power
when not
in use.)
Car
Battery
Cord ( Optional)
DC
IN
Connector
Cigarette
Lighter
Socket
(12V)
Car Battery Cord
(optional)
Cigarette
Lighter
Plug
JL
Connect
a
PV-C16
Car Battery Cord
(optional)
to DC
IN
on the Camcorder.
2First,
start
your car engine,
and
then
insert
the
Car Battery Cord
plug into
your cigarette lighter
socket.
*
A fuse is
located
in
the
lighter
plug
end
of
the
cord.
Should
fuse replacement
be
necessary
use
the
exact current
rating (in
amps).
Notes:
•
This
cord can only be
used
in
vehicles
equipped with
DC
12V
(negative
ground)
batteries. Use only the specified
car battery
cord.
If
you
are not
sure,
check with your local
car/truck dealer.
•
To avoid
blowing the fuse,
be sure
to
start
your
car engine before inserting
the cigarette lighter
plug of the Car Battery
Cord into
the
lighter
socket.
•
Because
the
car
is running
while
your
Camcorder
is in operation, make
sure
you're in a well ventilated
area.
•
Disconnect
the cigarette lighter
plug when
your Camcorder is not
being
used.
11