Panasonic PV-A208 - Battery Refresh Feature

Supplying
Power
Battery Refresh
Feature
This
feature
completely
discharges
the
Battery
before recharging begins.
To
maintain
your
Battery's
operating capacity, use the
refresh feature after
about
every five charges.
CHARGE Lamp
Battery
Care
Caution:
•
Charge
only with specified
charger.
•
Battery can be
charged within a temperature
range of
50°
F (10° C) and
95°
F
(35°
C).
•
Battery
may
be
warm after charging
or just
after use.
This
is normal.
•
Do
not
use
an insufficiently charged
or
worn-
out Battery.
Safety
precautions:
•
Do not
get
the
Battery near,
or
dispose
of in
fire.
•
Do not
directly connect (short circuit) the
positive
(+)
and negative
(-)
terminals.
•
Never attempt to disassemble or reassemble
the
Battery.
A.
Plug in the
AC
Adaptor.
•
The POWER
Lamp remains lit as long as the
AC
Adaptor
is plugged in.
Place
the
Battery
into
the
AC
Adaptor.
Press
the
BATTERY REFRESH
button.
The CHARGE Lamp
flashes
until
discharge
is complete and then stays
lit
until
the Battery
is fully charged.
Remove
the
Battery.
•
Should
you
accidentally
press
the
BATTERY
REFRESH button, remove the Battery
and
then re-insert
it
to
begin charging.
*
It takes
about
5 hours
when both
Battery
Refresh
and
recharging are performed.
To
avoid damage to the
Battery:
•
Do
not drop
or
jar
Battery.
•
Use
Battery
with
specified units
only.
•
If
Battery is
used in extremely high tempera-
tures,
a
safety
device will automatically
prevent
operation.
To
prolong battery
life:
•
While not
in
use, remove Battery from
the
Camcorder and AC Adaptor and store in
a
cool, dark, dry
place.
•
Keep Battery
terminals clean.
U.S.A. CONSUMERS:
ATTENTION:
The
product
you
have
purchased
is
powered
by
a
nickel
cadmium battery
which
is
recyclable.
At the end of its useful
life, under
various state and local laws,
it
is
illegal
to
dispose
of
this battery into
your municipal waste stream. Please
call
1-800-8-BATTERY
for information
on
how
to
recycle this
battery.
10