Panasonic PV-D4742 - Page 26

B. Install the Mechanism Chassis and Cassette Up Ass’y straight
onto the Main C.B.A. so that the Sensor LED clears the hole in
the Mechanism Chassis and that 2 Connectors (P4001, P6201)
are aligned and seated securely.
5. Flat Cable solder points on the Cylinder and AC Head
Solder the Flat Cables. Then, install the Shield Plate as shown.
Fig. D5
6. Installation of Cassette Up Ass’y
A. Confirm that the Locking Tab under the Cassette Up Ass'y is in
Hole on the Mechanism Chassis when installing the Cassette
Up Ass'y. Then, slide the Cassette Up Ass'y towards the back.
B. When installing 2 Screws (502), slide the Holder Unit (Refer to "
WHEN LOADING WITHOUT A CASSETTE" in Service Notes) to
tighten screws. Then, slide it back to the EJECT Position.
C. Hook Spring to the Drive Rack Arm on the Mechanism Chassis.
5.2. MECHANISM SECTION
26