Panasonic PV-DV101 - Page 18

EEPROM data menu, and then press "Enter" key.
4. Input the file name, and then press the "Enter" key. The data of
EEPROM IC will be stored to your PC.
2.How to write the EEPROM data which was stored in your PC to EEPROM IC
1. Start up the PC-EVR Adjustment Program.
2. Select "3. Read (Save)/Write All EEPROM data." in Main menu,
and then press "Enter" key.
3. Select "6. Writing from stored data files." in Read (Save)/Write All
EEPROM data menu, and then press "Enter" key.
4. Input the saved file name, and then press "Enter" key. The data of
EEPROM IC will be written in EEPROM IC.
3.How to initialize the EEPROM IC
When the Main C.B.A. is replaced, be sure to write the initial data to EEPROM IC. And adjust the
camcorder.
1. Start up the PC-EVR Adjustment Program.
2. Select "3. Read (Save)/Write All EEPROM data." in Main menu,
and then press "Enter" key.
3. Select "6. Writing from stored data files." in Read (Save)/Write All
EEPROM data menu, and then press "Enter" key.
4. Input the saved file name, and then press "Enter" key. The data of
EEPROM IC will be written in EEPROM IC.
OR;
Select "7. Writing of Initial data." and then press "Enter" key. And
press "Enter" key once again.
4.How to input ID Number
The ID number is in the EEPROM.
There are two ways to write the data of EEPROM IC after replacing Main C.B.A. as follows:
- Selecting "6. Writing from stored data files," ID Number with stored
data file will be written automatically.
- Selecting "7. Writing of initial data," ID Number needs to be input.
There are two methods, "a" or "b," to input ID Number as follows.
a When writing ID Number from the saved data:
1. Select "3. Read (Save)/Write All EEPROM data." in Main menu,
and then press "Enter" key.
18