2-6
11 Mechanism
Chassis
Guide Holes
Guide
Holes
Pin
Pin
Holder
Unit
Pin
Screw (G)
Screw (F)
Screw (F)
Spring (A)
Tab (C)
10 Cassette Up
Ass'y
Cassette Up Ass'y
Disassembly Procedure
1. Slide the Holder Unit (refer to "Method for Manual Loading/
Unloading of Mechanism" in Service Notes) to remove 2
Screws (F).
2. Remove Screw (G).
3. Unhook Spring (A).
4. Slide the Cassette Up Ass'y towards the front to release
Tab (C). Then, lift it up and remove.
Fig. D11
Reassembly Notes
1. Installation of Cassette Up Ass'y
1) Confirm that the 3 pins and Tab (C) under the Cassette
Up Ass'y are in each of the 4 Guide Holes on the
Mechanism Chassis when installing the Cassette Up
Ass'y. Then, slide the Cassette Up Ass'y towards the
back.
2) Tighten 2 Screws (F) and Screw (G).
Be careful not to tighten them too much, or the Cassette
Up Ass'y may be bent outward.
To Next Page
Loading...
