28
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Universal Remote Control is...
The Remote Control may be set up to control some
basic DSS or Cable box functions.
The Universal Remote Control Setup
1
Cable Box Universal Remote Control Feature
Using the Universal Remote Control
Press COMBO or DSS CABLE on the remote
control to select the desired mode. (See below for
buttons available in each mode.)
Once the remote control has been properly set up,
you can select COMBO, DSS or CABLE mode
depending on which functions you wish to control.
(See below.)
Find your DSS box or Cable box
Brand Code Number from one of
the charts on the next page.
3
Confirm code entry.
Press POWER* to turn selected unit
ON or OFF.
• See below for controllable functions in each
mode.
• Please repeat the Universal Remote Control
Setup after replacing remote control batteries.
• The remote control will not operate all DSS
receivers or Cable Boxes made by the
manufactures listed. If you get no results, your
particular brand cannot be controlled.
Set to COMBO:
• All TV and VCR functions.
Set to DSS CABLE:
• Basic VCR functions, e.g. PLAY, REC, etc.
• CABLE/DSS functions, e.g. POWER, ENTER,
number keys (except 100 key), CH UP/DOWN.
Notes
2
Setup remote.
Hold down DSS CABLE and press
number keys to enter code.
• For code 100 or greater, first press 100 key,
then the remaining digits. E.g. for 102, press
100, then press 0, and then press 2.
C2061- P28-29 Universal Remote 00.12.14, 5:33 PM28
To Next Page
Loading...
