7.3.7.2.1. How to adjust:
1. Press CH UP/DOWN key on the remote control to select control
function to be adjusted.
Important Note:
Make a note of the original value of the controls before modifying
in case the wrong control is adjusted.
2. Press VOL UP/DOWN key on the remote control so that the
shaded area moves to the value.
Fig. E5-2
3. Press CH UP/DOWN key on the remote control to adjust the value
of the selected control.
Fig. E5-3
Note:
You can select a desired channel by using the numbered keys on
the remote control in EVR adjustment mode.
4. Press VOL UP/DOWN key on the remote control so that the
shaded area moves to the control function.
Fig. E5-4
5. Press CH UP/DOWN key on the remote control to select a control
function for the next adjustment if necessary.
Fig. E5-5
63
To Next Page
Loading...
