7.3.15. V. HEIGHT/H. POSITION ADJUSTMENT
Purpose :
To set the standard vertical and horizontal picture size.
Symptom of Misadjustment :
The picture size is on the vertical and horizontal axis is abnormal.
Test Point:
----------
Adjustment:
V SIZE (EVR),
H CENTER (EVR)
V POSITION (EVR)
(Model: A, B, C, D, E, F, G)
Specification:
Refer to descriptions below.
Input:
Video Input Jack, Monoscope Pattern Signal
Mode:
STOP
Equipment:
NTSC Video Pattern Generator
(Model: A, B, C, D, E, F, G)
1. Supply a Monoscope Pattern Signal to the Video Input Jack.
2. Select H CENTER in EVR adjustment mode and adjust so that A is
approximately equal to width B.
3. Select V SIZE in EVR adjustment mode and adjust so that the top
3rd line is just in view.
76
To Next Page
Loading...
