Panasonic RAMSA WP-9055

READ THE FOLLOWING INSTRUCTIONS BEFORE USE
• This uni ( sho Id ve in st alled on a rig id, at sur a ce or
secured in a rae .
• Do at Instal t" e unit wi th the rear Side lachfj down .
• Do not put any obiect on lop of the unl"
• Due to the IohJling ci rc uit Iflcorpo ra ed , no sound is
produced for 4 D 6 sec on ds attr., tu rning on the power
supp y
• Alwa'l s use ~ ::lower source of adequa ,2 capaCITY
• Do not turn on the pow er of mu lt iple power ampl ifiers
a t the s am e ti rr e Nev er allow th e ventil ai 'on ho le s on
the
top and bottom of the ampl i fier to ge t obstruct ed
in any way .
, T~~.s unit is self-cooled. Always be su re there is adequate
ventilation In instal lation. Nev er block the vent holes on
the
top and bottom.
• To clean the amplifier, wipe It With a dry cloth . If the
ca se is very dirty, wipe it wi h a ClOth dampen ed i.
wat e or mild soapy water, hen \IV ipe dry thor ough 1 '1.
Never use so lvents or chern i ca l cloth ; Sllll, 'urly, never
spray 1$, ·( tlcldes as they I lay cause di sc oloration or
peeling.
• I
i any trou ble IS fou nd, disconnect '(h-: POWEl- cord and
cont act your de aler.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE,
MAJOR OPERATING CONTROLS
• Front panel:
--. .
~ j~~ . ";;";".
J r~ . .... rw. ...... __ ... _ • •
• Rear panel:
- 2 -