30
3.6 Example of systems for analog 16-track recorder (1 unit)
This is an editing system that uses AUTOMATION. The SMPTE timecode is recorded in the 16th
tape track of the analog 16-track recorder and the system works off this timecode.
Method of connection
Insert the option card WR-ADDA (Slot 1, 2) and WR-SMPTE in the WR-DA7 and firmly fasten them
to the main body with the supplied screws.
Connect the IN/OUT terminal using the recommended cable(Part # DA/DB-XLR M-F: Available in
the USA) of the WR-ADDA card of the WR-DA7 to the IN/OUT terminal of the analog 16-track
recorder.
The timecode is supplied from channel 16 of the analog recorder to the (optional) SMPTE IN
(XLR: 1,3-GND, 2-SIGNAL) of the WR-DA7.
WR-DA7 setting
Set the WR-DA7 to the wordclock master.
In the INPUT SET screen of D-I/O of the WR-DA7, set SOURCE SELECT to ‘INT 48k’ or ‘INT 44.1k.’
To display the SMPTE timecode being received at the SMPTE IN, set the TIME BASE to ‘SMPTE’ in
the EXECUTE screen of the AUTOMATION window.
To Next Page
Loading...
