Panasonic RAMSA WR-S216 - Rear Panel Connectivity Specifications

REAR PANEL
• WR-S208
(1) Insertion Jacks
1/4" TRS phone jacks. -10 dB. 10 kohms.
unbalanced
A post-equalizer and pre-fader patch-point
Tip: Return, Ring: Send, Sleeve: Common
Signal 'processing devices can be connected to
each input .
The
number of the Insertion Jacks are:
6 (WR-S20B). 10 (WR-S 2 12). 14 (WR· S216)
(2) Line Input Jacks
1/4" TRS phone jacks, ·30 dB to + 10 dB. 20
kohms, electronic balanced
Tip: Hot. Ring: Cold, Sleeve: Common
The number of the Line Input Jacks are:
6 (WR-S20B). 10 (WR-S 212), 14 (WR-S216)
(3) Mic Input Connectors
3-pin XL-type connectors. -60 de to -20 dB 5
kohms. electronic balanced '
Input connector exclusively for connecting a
microphone
Pin No.1: Common, Pin No.2: Hot, Pin No.3: Cold
The number of the Mic Input Connectors are:
8
(WR-8208). 12 (WR-S2121. 16 (WR-S216)
(4) Phono Input Jacks
RCA pin jacks. -56 dB, 50 kohms, unbalanced
To be connected with the output of a turntable.
Two turntables mrJY be connected .
(5)
Tape/Aux Input Jacks
RCA pin Jacks, -20 dB. 20 kohms, unbalanced
Connect a tape recorder or auxiliary line-level input
deVice to this jack .
- 11
(6) GND Terminal
G ND term i n al for turnta bles
(7)
Sub A/Sub B Output Jacks
1/4" TS phone Jacks, + 4 dB, 3 kohms.
unbalanced
Output jacks for Sub A and Sub B signals.
(8) Effect Return 1, Effect Return 2 Input Jacks
1/4" TS phone jacks, -20 dB. 20 kohms. un-
balanced. for connecting the outputs of effects
devices.
(9) Monitor Output Jack (WR-S208) or Connector
(WR- S212/WR-S216)
WR-S208: 1/4" TRS phone jack" 4 dB. 600
ohms, balanced
WR-S212IWR-S216 : 3-pin XL type connector. I 4
dB, 600 ohms. balanced
Output jack for pre-fader monitor signals.
(10) Send Output Jack
WR-5208 : 1/4" T5 phone jack. r 4 dB, 3 kohms.
unbalanced
WR-5212IWR-S 216 : 1/4" TRS phone jack . + 4 dB,
600 ohms, balanced
Output jack for pre-fader level or post-fader level
signals on the monaural input channels selected
by the Send selector switch.
When pre-fader level is selected, the same signals
as
monitor output Signals are sent . When post-
fader level is selected, the same signals as Effect
output signals are sent.