STAND
oTilting
the front
To
tilt the front
of
the set up, extend the stand and
place
the set
down
on the stand.
I lnstalling Rubber Feet
SHOULDER
STRAP
Attach the
Shoulder Strap by following the illustration,
below:
Note:
While
carrying
the
set
with the Shoulder Strap, be careful
not to
accidentally knock
off
the rubber
feet
(if
installed).
W
q.
rubber
foot
1
@,inctuded)
(e
I
remove
the
tape
installation location
To use
the
set on a steel surface or to
prevent
it from slipping,
install
the 4 rubber
feet
provided.
To intall, first remove the tape from each
foot,
to expose the
adhesive. Then, secure each
foot
to the bottom of
the cabinet,
as shown in the figure.
N
-7
-
To Next Page
Loading...
