13
TQBJ2029
Connecting a device
Preparation
If this system is connected to a
Bluetooth
®
device, disconnect it
(Z“Disconnecting a device”).
1 Press [ ].
“Bluetooth Ready” is shown.
2 Select “RF-D20BT” or “RF-D20U”
from the Bluetooth
®
menu of the
device.
3 Start playback on the device.
Press [4/9] to pause or resume the
playback.
Note:
• A device must be paired to connect.
• This system can only connect to one
device at a time.
• When “Bluetooth” is selected as the
source, this system will automatically try
to connect to the last connected device.
Disconnecting a device
While a Bluetooth
®
device is
connected
1 Press [MENU].
2 Press [ TUNE/SELECT ] to
select “Disconnect” and then
press [ENTER].
3 Press [ TUNE/SELECT ] to
select “Yes” and then press
[ENTER].
“Bluetooth Ready” is shown.
To cancel, select “No”.
Alternatively, press and hold [ ] until
“Pairing” is shown to disconnect the
device.
D20BT_en_gn.fm Page 13 Monday, June 12, 2017 1:56 PM
To Next Page
Loading...
