Panasonic RN-109 - Circuit Boards and Wiring Diagram

1 2 3 4
5
CIRCUIT BOARDS AND WIRING CONNECTION DIAGRAM
Back Side View
oro
80 YO
[TES OT) [SfFASDeS]) [SFASD2S]
Example
Components
30
[STASD2S]
, Front P.B
pattern
anza
— 7T—
eo
[SfASD2S)
SPEAKER
1C1
IBA515M])
ip isw [so [9] 20a"
zt om fe] ov [io] 276v
ret ia fo] iaev fie] 1aav_
TERMINAL-A |
ro
[STASDeS)
[| vse.0 | @|
v9.0
TERMINATIONS
€O
[STASI2S]
sO
[STASDeS]1
[| voa.0 | 8 |
2S
1
1C101
NOTES:
© The circuit shown in “~~ on the conductor indicates printed circuit
on the back side of the printed circuit board.
e The circuit shown in» »» on the conductor indicates printed circuit
on the front side of the circuit board, which is put the mechanism unit.
© Components on back of P.B are identified by black symbols.
° Components on front of P.B are identified by blue symbois.
© The symbols (@) shown in the circuit board indicate connection points
between conductors on the front side and back side of the circuit
board.
° Voitage values shown in|___ are measured values at the front
pattern side of the printed circuit board.
© Voltage values shown in =| are measured values at the back
‘| TERMINAL-B
BATTERY eR A
|
giiw
bsel
s
dtiw
eliot
foennooe1
tit
oweeerg
Ismment
sonie
.bseu
ei
bordiem
Cathodes 2— Anode
cao G—
D3
pattern side of the printed circuit board.
° Values indicates in {__ fare DC voltage between the chassis
and electrical parts.
° All voltage values shown in circuitry are under no signal condition.
Unless otherwise specified, voltage measurement conditions are that
tape travel is at PLAYBACK.
° This circuit board diagram may be modified at any
time with the development of new technology.
TIA
aAUe!|TAG
JAMASHT
betoennoseib
ed
O94
bluode
«
[vos fa] veto [S|
| veat [<| velt |
vaso [s| voes [¥)
‘weiV ebi2 ino
roro
(r88AeS]
rorol
[BraeNA)
Black Brown
Chip
Chip
Resistor Capacitor
and Chip
Jumper