Operation
12
Useful functions
You can activate the voice control function of your Bluetooth
®
device (smartphone, etc.) and control the device
by speaking to the microphone of the unit.
1 Connect the Bluetooth
®
device and the unit. (l 8, “Connecting a Bluetooth
®
device”)
2 Press and hold [ ] of this unit for approx. 3 seconds.
• The voice control app on the Bluetooth
®
device will be activated.
Note
• For details about voice control commands, refer to the operating instructions for the Bluetooth
®
device.
• Depending on the device, a voice control function may not be available.
This unit can be reset when all operations are rejected. To reset the unit, press and hold [Í/I ( )] for
10 seconds or more. All the previous operations will be cancelled. (The pairing device information will not be
deleted.)
If the unit is not connected to a Bluetooth
®
device, the unit will beep and turn off automatically approximately
5 minutes after you have stopped using it.
When the battery level is low during use of the unit, the blue blinking LED will change to red. A beep will sound
every 1 minute. When the battery runs out, the power will turn off.
Activating a voice control function
Resetting the unit
Auto power off
Battery level notification
To Next Page
Loading...
