Panasonic RQ-V185 - Listening to Radio Broadcasts (continued); Reception Tips; FM Mode Selector

When receiving the FM stereo broadcasts, the stereo indicator will
appear.
When you listen to the FM broadcast, set the FM mode selector
to the proper position.
4 Adjust the volume using the volume control.
To turn off the radio, set the function selector to “TAPE/[ofF]”.
To obtain good reception--
Antennas
FM:
The headphones'cord serves as the FM antenna, hence be sure to
use it extended, not coiled.
AM:
The built-in ferrite core AM antenna is directional. It may be necces-
sary to turn the unit to obtain optimum reception.
Note:
Be sure to have the set in a horizontal position when you listen to AM
broadcasts. If you use the radio in an upright position, it may not
function adequately.
FM mode selector
MONO/
CrQ2fMTLU
STEREO/NOR • rrn
FM'MODE/ li ™
TAPE
To receive FM stereo broadcasts, set the FM mode selector to
"STEREO”. If reception is poor (excessive noise), set to “MONO”.
This will reduce the noise and provide clear reception, however, the
broadcast will not be heard in stereo.
13