Sensors/Infrared transmitters and receivers
Wash
in water
● After washing with water...
• Remove water and dry completely.
(To avoid odor)
• Please do not use a blow dryer or similar to dry it
(to avoid deformation and malfunction)
●
Do not use substances such as detergent, benzene, thinner, or alcohol
(to avoid cracks and color change)
●When using chemical wiping cloths, be sure to observe the
accompanying instructions.
● The side brush collects hair and waste easily, so check regularly and
perform maintenance as necessary.
Request
● The side brush is replaceable.
They wear down at different rates according to the type of fl oor they
are being used on.
Replace the side brush when bristles start falling off or when they get
damaged.
• You can purchase the side brush from the retailer where you
purchased the unit.
Note
●Wring fi rmly
Charging base
Infrared
transmitter
Fall prevention sensors
Roller
( with built-in
drive sensor)
area is to be wiped with a soft damp cloth
Approx. once a month
Infrared sensor
Infrared receiver
Ultrasonic sensors
Wash
in water
Wipe with a soft damp cloth
●Wring fi rmly
EN23
Maintenance
To Next Page
Loading...
