Panasonic RX-1490/A - Controls and Components Location; Front Panel Controls and Indicators; Rear and Side Panel Connections; Disassembly Instructions

RX-1490/A
LOCATION OF CONTROLS AND COMPONENTS
@ Tape Counter and Reset Button (COUNTER)
6) © @® ® @M @ @ Cassette Compartment
@ LED Power Indicator (POWER)
@ LED Record Indicator (RECORD)
©) Pause/Eject Button (PAUSE/EJECT)
© Stop Button (STOP)
@ Fast Forward/Cue Button (FF/CUE)
Rewind/Review Button (REW/REVIEW)
@ Playback Button (PLAY)
Record Button (RECORD)
Selector Switch (SELECTOR)
[POWER OFF /TAPE, AM, FM]
42 Telescopic Antenna
43) Tone Control (TONE)
Volume Control (VOLUME)
45) Tweeter [3 cm (13/16"’) 40]
Tuning Control (TUNING)
4? Built-In Microphone (MIC)
EXT. MIC Jack [0.25 mV(-—72 dB ) 200~60012]
EXT. SP Jack [3~80]
Fig. 1 @ @ AC Socket
@t) Woofer [12 cm (423/32"’) 3Q]
DISASSEMBLY INSTRUCTIONS
@)
Pee ©
=
(ee)
{
© ©
Fig. 3 (G) (K) (J) (D) Fig. 4 (L)
*1. When the tape is caught in the pinchi roller, etc.
Remove this cap and release the tape by turning the pulley on the motor with the
screwdriver in the direction of the arrow as shown in Fig. 2.
*2. Toremove the handle arm, cut the rib of handle arm.
*3. Push the leg of cassette panel in the direction of arrows as shown in Fig. 4.
*4, Put in the deck, watching the recording rod is set in the recording lever, as
shown in Fig. 5.
Mechanism (*4)
Main Circuit Board
Power Circuit Board
Cassette Panel