Panasonic RX-DS16 - Programmed CD Playback

Listening operations Pe
Total number
of tracks
TUNE/SKIP/SEARCH
Track number
Listening to CDs
Program play
You can program up to 24 tracks.
Before operation:
Program play cannot be used in combination with random play. When
“(PaNDOM)” is displayed, press CD PLAY MODE to clear the display.
Press »/Il, then press M CLEAR after the track
number has been displayed.
The total number of tracks and total play time of the CD are
displayed.
Press -Atd or +> to select the desired track.
Press MEMORY.
a gap is displayed.
Repeat steps 2 through 3 until you -have programmed
all the tracks you want.
Press > / |I.
Play will start in the programmed sequence.
When all programmed tracks have been played, “Cd-P” and the total
play time will be displayed. EX
To cancel program play:
Press W CLEAR in stop mode to display “CLR”.
Pressing & CD OPEN will cancel program play.
When “-—:- —" appears: E
This means that the total play time of the programmed tracks has
exceeded 120 minutes. Tracks can still be programmed and played.
When “FULL” appears:
The number of programmed tracks is limited to 24. No further tracks
can be programmed.
To check what has been programmed:
Press -At or +/1 when “Cd-P” is displayed at the end of the
program. |
The display will show the track number and programmed sequence.
Memory retention of programmed tracks:
The memory retains the program even if play is stopped or the unit is
turned off. o ;
è During program play, you can search forward or backward only
within the current track.
è During program play, skipping is always in the programmed order,
whether forward or backward.