Panasonic RX-DS16 - Radio Operations; Presetting Radio Broadcasts

| Presetting radio broadcasts
@ Up to ten FM and AM stations each can be programmed.
è lf broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies.
è You can preset just those stations you like.
Cie” |
lest
—.-3 hme jl
Press BAND to select “FM” or “AM”.
Every time you press the button: FM + AM
Press MEMORY.
* EAN ” and the frequency flash.
While “ GAM ” and the frequency are flashing: ©
Press -t4 or +> to select the desired station.
| “BEEJ” lights when an FM stereo program is being received.
Reference j |
You can select the desired broadcast by using “Automatic
. tuning”. (See page 8.) l
MEMORY
Press
MEMORY.
” (ZAN ” and the preset channel number flash.
Listening operations a
While “ GAM ” and the preset channel number are
flashing:
Press -Ad or +P to select the preset channel.
Nr
Press
MEMORY.
Lo
Du
ny
If
the
“
GE
”
indicator
goes
off
during
programming,
return
I.
to
step
2.
LT N
Repeat steps 2 to 6 to program other stations.
I
"MEMORY
To erase an unwanted preset channel
e.g. erasing preset channel 3. i
1. Select preset channel 3 (see page 8).
2. Press MEMORY twice ("ar " and the preset channel number
flash). x". at
While “Gen” and the preset channel number are flashing:
Press -A44 or +1 repeatedly until the preset channel
display indicates “— —”.
. Press MEMORY.
w
de
The erased preset channel will now be skipped when selecting preset
| channels. (e.g. 1-*24~5....)
FM allocation setting
cl M By adjusting the allocation, you can enable this tuner to receive FM
we : ~ broadcasts allocated in 0.1 MHz steps.
1, Press and hold BAND for approximately 5 seconds during AM
display. The frequency display will be returned to the minimum
frequency of the FM band and the display will begin to flash. Keep
holding for approximately 5 more seconds.
When the display stops flashing and indicates a different frequency
number, release BAND.
N
To return to the original frequency, repeat steps 1 to 2 above.
After changing the “allocation” setting, the frequencies you previously
preset in the memory will be cleared.