Panasonic RX-FT510 - Radio and Tape Playback; Radio Operation; Tape Playback Functions

RADIO
1. Set the Function Selector to ‘‘RADIO’’.
2. Set the Band Selector to the desired radio band.
3. Tune in your favourite station using the Tuning Control.
4. Adjust the Volume and Tone Controls to the desired
settings.
5. The radio can be turned off by setting the Function
Selector to “TAPE/ ToffI ”.
Notes:
•To receive FM stereo broadcasts, set the Band
Selector to "FM STEREO”. The FM Stereo Indica¬
tor will light during stereo broadcasts.
•If FM stereo reception is poor {excessive noise, FM
Stereo Indicator flickers), set the Band Selector to
“FM". This will reduce the noise and provide clear
reception: however, the broadcast will not be heard
in stereo.
n Antennas
FM:
Pull out the Telescopic Antenna and adjust its length and
angle for optimum reception.
AM:
The sensitive ferrite core antenna inside the set will provide
excellent AM reception in most areas. For optimum recep¬
tion, turn the set in the direction which gives the best results
since the ferrite core antenna is directional.
This unit has a dual cassette system. A tape can be played
back with Deck 1 and Deck 2.
■ Single Tape Playback
1, o pen the Cassette Compartment cover by pressing the
Stop/Eject Button. Insert the playback tape as shown in
the figure, and then close the Cassette Compartment
cover.
2. Set the Function Selector to “TAPE 4o^ ’‘.
3. Press the Playback Button to begin tape playback.
4. Adjust the Volume and Tone Controls.
5. To stop the playback, press the Stop/Eject Button.
■ Automatic Playback Relay (Deck 1 to Deck 2)
When Deck 1 playback has finished. Deck 2 playback starts
automatically.
1. Insert the playback tapes into Deck 1 and Deck 2.
2. Press the Deck 1 Playback Button.
3. Press the Deck 2 Pause Button, then press the Playback
Button.
■ Fast Forward and Rewind
The tape will move rapidly forward when the Fast Forward
Button is pressed.
The tape will rewind rapidly when the Rewind Button is
pressed.
Note:
Do not press the Playback Button during fast forward
or rewind, as this may jam the tape. Always press the
Stop/Eject Button first, between functions.
■ Cue and Review
If the Cue Button (or Review Button) is partially pressed
during playback, the recorded sound on the tape can be
monitored at a fast speed.
When the button is released, playback will resume.
- 5 -