To Next PageTo Next PageWhy is my Panasonic S-125PF1E5A not cooling or heating properly?
If your Panasonic Air Conditioner isn't cooling or heating well, check if the air intake or outlet of the indoor and outdoor units is blocked with dust and remove any dust. You can also try setting the fan speed to “High” or “Strong”.
What to do if my Panasonic Air Conditioner does not turn on?
If your Panasonic Air Conditioner isn't turning on, even though it's plugged in, first, press the power ON/OFF button on the remote controller. Also check the breaker. If the breaker is turned off, turn the power on. If the breaker has been tripped, consult your dealer without turning it on.
General| Brand | Panasonic |
|---|---|
| Model | S-125PF1E5A |
| Category | Air Conditioner |
| Language | English |
Ensures proper installation by qualified technicians and checks electrical voltage compatibility.
Details electrical wiring requirements, grounding, and the need for a qualified electrician.
Instructions for powering on the unit 5 hours before operation for warm-up.
Specifies the indoor and outdoor temperature ranges for cooling and heating modes.
Identifies components of the U1, T2, and F1 type indoor units.
Identifies components of PE1 and PEY1 type outdoor units.
Explains how outdoor air affects heating performance due to the heat pump system.
Describes the defrosting operation process and indicators for the indoor unit fan.
Details the 'DRY' operation cycle, fan behavior, and temperature limitations.
Explains how the unit resumes operation after a temporary power failure.
Instructions for adjusting airflow direction using the timer remote controller.
Instructions for adjusting airflow direction using the wireless remote controller.
Guidance on setting vertical airflow for heating, cooling, and fan modes.
Manual adjustment of horizontal airflow vanes for the T2 type.
Steps to adjust airflow direction for individual indoor units using a timer remote.
Steps to adjust airflow direction for all indoor units simultaneously using a timer remote.
Advice on energy saving, including filter cleaning and closing openings.
Instructions for cleaning the indoor unit, including wiping and washing the flap.
Procedure for washing the air outlet flap with water, ensuring it dries before reattachment.
Guides users on initial troubleshooting steps for common issues before contacting a dealer.
Identifies causes for various noises heard during or after operation.
Explains that odors may be due to accumulated indoor components or a dirty unit.
Explains dewdrops are caused by internal moisture cooling from the air.
Explains fog formation is due to internal moisture cooling from the air.
Indicates that fog during heating operation means defrost operation is in process.
Fan rotation after stopping is for smooth operation or drying the heat exchanger.
Addresses issues with airflow direction changes, setting, and flap movement.
Explains that dust discharge is due to accumulation inside the indoor unit.
Fan speed variation at startup is for operation check within the motor's range.
Explains that no operation for the first 3 minutes is due to compressor protection.
Indicates noise during heating operation means defrost operation is in process.
Explains steam during heating is for smooth operation.
Fan rotation after stopping is for smooth operation.
