35
Necessity of setting changes by combination of each method
Type of combination: Necessity of setting
Method 1 only: Setting is unnecessary.
Method 2 included: Setting up in common use of a solenoid valve kit from “Remote Control” is
necessary. *
1
* Method 2 only is set.
* Method 3 excluded
Method 3 included: Setting up in common use of a solenoid valve kit from a specific program
settings software is necessary. *
1
* Setting all connected indoor units
* Contact your local distributor to obtain a specific program settings software.
*1: Refer to “Test Run” for setting instructions.
Please note the following system example is prohibited and avoid the following connection.
Solenoid
valve kit
Indoor unit
Remote
controller
Indoor unit
Remote
controller
Indoor unit
Remote
controller
Indoor unit
Remote
controller
Solenoid
valve kit
Method 3 individual control is possible and group wiring should be
made by other solenoid valve kit.
Indoor unit
System 1
Solenoid
valve kit
Indoor unit
Remote
controller
System 2
Group wiring should be made by different type
of refrigerant.
Solenoid
valve kit
Indoor unit
00_341136_2WAY_Eng.indb 35 2022/9/19 9:27:27
To Next Page
Loading...
