2WAY SYSTEM
Remote Controller Functions
5 - 9
2. Detailed Settings Function
5
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position 1 . (refer to Fig.4)
* Setting data “ ” (refer to Fig.4)
Flap position
1
7
Press the timer time
the desired setting data.
/
buttons to select
(The display stops blinking and remains lit, and setting
is completed.)
If you wish to change the selected indoor unit, follow
the step .2
6 Press the button.
Press the
controller display.
button to return to normal remote
2
3
4
5
6
1
7
When the flap position is set to 4 or 5 and the unit
is in the cooling or dry mode, the flap position is moved
to 3 and the operation is started. (refer to Fig.4)
Flap position during operationSetting data
Move to position 1 and stay
Without separate setting
Swing
Move to position 2 and stay
Move to position 3 and stay
Move to position 4 and stay
Move to position 5 and stay
2
3
4
5
Fig. 4
NOTE
Setting the Flap Separately (When setting the CZ-RTC2)
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps operate
in the same manner.
<Procedure>
Stop the system before performing these steps.
4
1
Press and hold the
simultaneously for 4 seconds or longer.
,
and buttons
2
If group control is in effect, press the
button and select the address (unit No.) of the
indoor unit to set. At this time, the fan at the indoor
unit begins operating.
Designate the item code “
Temperature Setting buttons./
“ by adjusting the
3
“ ,” unit No. “
=91
=90
” (or “ ” in the case of
group control), item code “ ,” and settings data
controller LCD display.
“” are displayed blinking on the remote
=92
=93
Air discharge
port
Flap
(adjustment for up-down airflow direction)
Electrical component box
Flap 1
Flap 3
Flap 2Flap 4
SM830204-05_2WAY SYS.indb 9 2015/01/23 11:57:27
To Next Page
Loading...
