Panasonic S-36MK2E5A - Page 41

5 - 18
2. Detailed Settings Function
5
VRF SYSTEMS Indoor Unit
(Continued from previous page)
Item code Item Description
3C
Heat exchanger temperature for
cold air discharge
The heat exchanger temperature control point for prevention of cold air
discharge during heating operation can be changed.
3d Fan output switching
The indoor unit PCB optional output for the fan can be switched
according to the purpose of use.
3E Drain pump delayed start time
The drain pump starts after the set time delay after cooling operation
stops.
40 Humidifi er drain pump setting This specifi es the humidifi er and drain pump setting.
45 DC fl ap operation mode Changes fl ap operation to draft reduction mode.
46 DC fl ap swing mode Selects the swing operation mode for the fl ap.
5d DC fan tap setting
Sets the DC fan tap according to the purpose of use.
Change the settings data at the same time.
5E Humidifi er ON time
Sets the humidifi er output ON time for when the humidifi er is operating.
ON/OFF control is performed during humidifi er operation.
This setting therefore sets the ON time per 60-second interval.
5F
Stop at time set for OFF timer after
operation starts
This setting enables a function that stops operation when the amount
of time set for the OFF timer has passed after remote controller
operation was started.
60 Timer function change prohibit
This function prohibits changes from being made to the remote
controller time setting.
62 Smudging control Smudging control is disabled when 0000 is set.
SM830232-00欧州向けVRFIndoor201404.indb18SM830232-00欧州向けVRFIndoor201404.indb18 2014/04/2511:11:142014/04/2511:11:14