Panasonic S-36PF1E5A - Page 3

When Connecting Refrigerant Tubing
WARNING
• When performing piping work do not
mix air except for specified refrigerant
(R410A) in refrigeration cycle. It
causes capacity down, and risk of
explosion and injury due to high
tension inside the refrigerant cycle.
• Refrigerant gas leakage may cause
fire.
Do not add or replace refrigerant other
than specified type. It may cause
product damage, burst and injury, etc.
•
• Ventilate the room well, in the event that is
refrigerant gas leaks during the installation.
Be careful not to allow contact of the
refrigerant gas with a flame as this will
cause the generation of poisonous gas.
• Keep all tubing runs as short as possible.
• Use the flare method for connecting tubing.
• Apply refrigerant lubricant to the matching
surfaces of the flare and union tubes before
connecting them, then tighten the nut with a
torque wrench for a leak-free connection.
• Check carefully for leaks before starting
the test run.
• Do not leak refrigerant while piping work
for an installation or re-installation, and
while repairing refrigeration parts.
Handle liquid refrigerant carefully as it
may cause frostbite.
When Servicing
• Turn the power OFF at the main
power box (mains) before opening
the unit to check or repair electrical
parts and wiring.
• Keep your fingers and clothing away
from any moving parts.
• Clean up the site after you finish,
remembering to check that no metal
scraps or bits of wiring have been left
inside the unit being serviced.
WARNING
•
•
•
This product must not be modified
or disassembled under any
circumstances. Modified or
disassembled unit may cause fire,
electric shock or injury.
Do not clean inside the indoor and
outdoor units by users. Engage
authorized dealer or specialist for
cleaning.
In case of malfunction of this
appliance, do not repair by
yourself. Contact the sales dealer
or service dealer for repair.
CAUTION
•
•
Do not touch the air inlet or
the sharp aluminum fins of the
outdoor unit. You may get injured.
Ventilate any enclosed areas when
installing or testing the refrigeration
system. Escaped refrigerant gas,
on contact with fire or heat, can
produce dangerously toxic gas.
•
Confirm after installation that no
refrigerant gas is leaking. If the gas
comes in contact with a burning
stove, gas water heater, electric
room heater or other heat source,
it can cause the generation of
poisonous gas.
Others
WARNING
CAUTION
•
•
•
Do not sit or step on the unit,
you may fall down
accidentally.
Do not touch the air inlet or
the sharp aluminum fins of
the outdoor unit. You may get
injured.
Do not stick any object into
the FAN CASE.
You may be injured and the
unit may be damaged.
ii
SM830231-02Single欧州.indbSec1:iiSM830231-02Single欧州.indbSec1:ii 2014/09/1117:38:522014/09/1117:38:52