1-1631-162
6-44. Accessories Supplied with Unit
(4-Way Cassette 36” × 36”)
Part Name Figure
Q’ty
Remarks
Washer
8
For suspension
bolts
Screw
4
For full-scale
installation diagram
Insulating
tape
2
For gas and liquid
tube flare nuts
Flare insulator
1For liquid tube
Flare insulator 1For gas tube
Drain hose
1
Hose band
1
For securing drain
hose
Drain socket
1
Packing 1 For drain hose joint
Drain
insulator
1
Part Name Figure
Q’ty
Remarks
Full-scale
installation
diagram
1 Card board
Part Name Figure
Q’ty
Remarks
Wire
mounting
bracket
1
Wire cover
1
Clamper
1
Screw
3
For wire mounting
bracket and wire
cover
Part Name
Figure
Q’ty
Remarks
Operating
Instructions
1
Installation
Instructions
1
Warranty
card
1
Use 3/8” (M10) for suspension bolts.
Field supply for suspension bolts and nuts.
00_271724_Eng.indb 5 2015-8-26 14:43:50
Set screw only for transportation
Fig. 1-144
Fig. 1-145
Fig. 1-146
Fig. 1-147
Fig. 1-148
Rear panel
Wall Mounted (Type K2)
6-45. Remove the Rear Panel from the Unit
(1) Remove and discard the set screw on the rear panel.
(Fig. 1-144)
(2) Press the 2
marks on the frame cover and disengage the
stationary tabs from the frame. (Fig. 1-145)
(3) Remove the rear panel by grasping the sections shown in
Fig. 1-146 and pulling it in the direction shown by the arrow.
NOTE
Tubing can be extended in 6 directions as shown in Fig. 1-148.
Select the direction you need providing the shortest run to the
outside unit.
When left tubing is to be done, switch the drain hose and
drain cap. (For details, see the section “Switching drain hose
and drain cap” on page 1-168.)
6-46. Make a Hole
(1) Place the rear panel from the indoor unit on the wall at the
location selected. Make sure the panel is horizontal, using a
carpenter’s level or tape measure to measure down from the
ceiling. Wait until after cutting the hole before attaching the
rear panel to the wall.
(2) Determine which side of the unit you should make the hole for
tubing and wiring. (Fig. 1-149)
NOTE
In the case of left-rear tubing, use the measurement points
158 mm from the marked position on the rear panel for precise
placement of the hose outlet. (Fig. 1-149)
(3) Before making the hole, check carefully that no studs or pipes
are directly run behind the spot to be cut.
CAUTION
Also avoid areas where
electrical wiring or conduits
are located.
The above precautions are also applicable if tubing goes
through the wall in any other location.
6-7/32
"
(158 mm)
5-3/16" (132 mm)
Unit: inch (mm)
Fig. 1-149
marks
Rear panel
Rear panel
Left tubing
Left-rear
tubing
Left-downward tubing
Right-downward tubing
Right tubing
Right-rear tubing
(recommended)
00_271673_Eng.indb 8 2015-9-1 13:07:57
1
SM830203-04.indb 163 15/10/16 10:45:13
To Next Page
Loading...
