Panasonic S-36PY1E5

1
1-387
(4) Setting the Flap Separately (When setting the CZ-RTC2)
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
<Procedure>
Stop the system before performing these steps.
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
If group control is in effect, press the
button
and select the address (unit No.) of the indoor unit
to set. At this time, the fan at the indoor unit begins
operating.
“
,” unit No. “ ” (or “ ” in the case of
group control), item code “
,” and settings data
“
” are displayed blinking on the remote
controller LCD display.
Designate the item code “
” by adjusting the
Temperature Setting
/ buttons.
=91
=90
=92
=93
Air discharge
port
Flap
(adjustment for up-down airflow direction)
Electrical component box
Press the timer time / buttons to select the
desired setting data.
Flap position
1
2
3
4
5
Fig. 1-22
* Setting data “
” (refer to Fig. 1-22)
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
When the flap position is set to
4
or
5
and the unit
is in the cooling or dry mode, the flap position is
moved to
3
and the operation is started. (refer to
Fig. 1-22)
NOTE
The flap swings during the operation under “Setting
the Flap Separately”.
At this time, the unselected flaps are moved to the
position
1
. (refer to Fig. 1-22)
Press the button.
(The display stops blinking and remains lit, and
setting is completed.)
If you wish to change the selected indoor unit,
follow the step .
Press the
button to return to normal remote
controller display.
2
2
2
3
3
4
4
5
5
6
6
1
1
7
7
SM830211-07PAC-i.indb387SM830211-07PAC-i.indb387 2013/09/1722:48:222013/09/1722:48:22