Panasonic S-50PY2E5A - Adjusting Airflow Direction; Using Wired Remote Controller; Recommended Vertical Airflow

6
Airow
direction
display
Press the
twice to select the FLAP.
AdjustingAirowDirection

Usingthehigh-specwiredremote
controller
Press / to select your desired airow direction.
STOP
STOP
Flapswingmotion
Display when swing operation
is stopped
z
Pressing
or
during swing can stop
the ap at your preferred
position.
Recommendedverticalairowdirection
z
Set the ap to the downward position for heating operation.
(With the upward setting, warm air cannot reach the oor.)
z
Set the ap to the upward position for cooling operation.
(With the downward setting, condensation may drip on to the
oor.)
HEAT COOL / DRY FAN
Fan and
heating
Cooling and
drying
(5 levels) (3 levels)
Recommended
Recommended
Fixed to this
position
This section is described in the instruction manual supplied with the high-spec wired remote controller (CZ-RTC3).
Regarding the timer remote contoller (CZ-RTC2), refer to the Operating Instructions supplied with the model CZ-RTC2.
Adjusting the upward and downward motion of airow direction
Flapxed
(5 levels)
OI_00_038226_EU.indb 6 2014/7/10 9:08:18