Panasonic SB-MAF7000PU

2
1 Specifications
2 Disassembly and Assembly Instructions
Caution Note:
• This section describes procedures for checking the operation and replacing the main components.
• For reassembly after operation checks or replacement, reverse the respective procedures.
• Special reassembly procedures are described only when required.
• Before carrying out the disassembly process, please ensure all the safety precautions & procedures are followed.
• During the disassembly and/or assembly process, please handle with care as there may be chassis components with sharp
edges.
• During replacement of component parts, please refer to the section of “Replacement Parts List” as described in the service man-
ual.
• Select items from the following indexes when disassembly or replacement are required.
Speakers (SB-MAF7000PU/GS, SB-MAG7000PU/GS)
• Disassembly of Front Panel Block
• Disassembly of Tweeter Speaker (SP1)
• Disassembly of Woofer Speaker (SP2)
• Disassembly of Lighting Wire P.C.B. Assembly
Subwoofer Speaker (SB-MAW7000PU/GS)
• Disassembly of Front Panel Block
• Disassembly of Subwoofer Speaker (SP3)
• Disassembly of Lighting Wire P.C.B. Assembly
Speakers (SB-MAF7000PU/GS, SB-MAG7000PU/GS)
Speaker unit(s)
Tweeter 6 cm cone type
Woofer 20 cm cone type
Impedance 3 Ω
Dimensions (W x H x D) 407 mm x 260 mm x 258 mm
Mass 5.5 kg
Subwoofer Speaker (SB-MAW7000PU/GS)
Speaker unit(s)
Super Woofer 30 cm Cone type
Impedance 6 Ω
Dimensions (W x H x D) 402 mm x 450 mm x 386 mm
Mass 13 kg
Notes:
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum ana-
lyzer.