terminals and negative (black) wires to negative (-) terminals.
6. Disassembly Procedure
“ATTENTION SERVICER”
Some chassis components may have sharp edges.
Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation of
the major printed circuit boards and replacing the main
components.
2. For reassembly after operation checks or replacement, reverse
the respective procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or
replacement are required.
Contents
- Disassembly of the Speaker Unit
- Main Component Replacement Procedures
6.1. Disassembly of the Speaker Unit
Step 1: Remove 2 screws from the rear panel.
To Next Page
Loading...
