9
Installation
Where to install
■
If the product is used or stored in a hot spring or coastal area, it may be
damaged (due to sulfur or salt).
■
If the product is used in a very cold or freezing location it may be damaged.
If you intent to install the product in any of the above areas or locations,
consult with the supplier or dealer where you purchased the product.
Installation
■ This is a product for installation and use
indoors.
Install on a flat place providing suitable
support, and take measures to prevent
overturning.
■ Clear the area around the product by at least 10cm for waste heat dispersal
and ventilation.
■ After installation, secure the product with the adjusting bolts on the front
side (two points on each side).
■ Fasten the adjusting bolts until the distance between the castor and the
floor is approximately 5mm.
After that, tighten the nut securely.
Keep the product away from :
■ Rainwater, a sink, or excessive humidity.
■ Outdoor.
■ Direct sunlight, or excessive heat (e.g. oven, stove), or
■ Excessive dust metal powder or corrosive gases.
10cm
10cm
CMT-6-P110-113-00-0.indd 9CMT-6-P110-113-00-0.indd 9 05/15/12 8:09 AM05/15/12 8:09 AM
To Next Page
Loading...
