- 25 -
Others
You can turn the beep sound on/off.
Touch and hold both [-WPS] and [VOL –] until the mode indicator
(amber) blinks.
The indicator blinks once: on (default)
The indicator blinks twice: off
≥ If the network indicator is blinking in blue and red, wait until the blinking stops.
To check the Wi-Fi signal strength where the unit is located.
If you are playing music on the network, stop the playback.
Touch and hold both [-WPS] and [AUX].
≥ The mode indicator (amber) blinks once and then blinks again to show the
Wi-Fi signal strength.
– If the mode indicator (amber) does not blink again, the unit is not connected
to the network.
≥ If the network indicator is blinking in blue and red, wait until the blinking stops.
≥ If the Wi-Fi signal strength cannot be checked, deselect the unit from AllPlay/
DLNA speakers, and try again.
Operation sound setting
Wi-Fi signal strength
Number of blinks Wi-Fi signal strength
1
2
3
Weak
Strong
To Next Page