@
Selecting fine audio equipment such as the unit you've just pur-
chased is only the start of your musical enjoyment. Now it's time to
consider how you can maximize the fun and excitement your equip-
ment offers, This manufacturer and the Electronic Industries Associ-
ation's Consumer Electronics Group want you to get the most out of
your equipment by playing it at a safe level. One that lets the sound
come through loud and clear without annoying blaring or distortion--
and, most importantly, without affecting your sensitive hearing.
We recommend you to avoid prolonged exposure to excessive
noise.
Sound can be deceiving. Over time your hearing "comfort level"
adapts to higher volumes of sound, So what sounds "normal" can
actually be loud and harmful to your hearing.
Guard against this by setting your equipment at a safe level
BEFORE your hearing adapts.
To establish a safe level:
eStart your volume control at a low setting.
eS[owly increase the sound until you can hear it comfortably and
clearly, and without distortion.
Once you have established a comfortable sound level:
eSet the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage
or loss in the future. After all, we want you listening for a lifetime.
CAUTION!
DO NOT INSTALL OR PLACE THIS UNIT IN A BOOK-
CASE, BUILT IN CABINET OR IN ANOTHER CONFINED
SPACE IN ORDER TO KEEP WELL VENTILATED CONDI-
TION. ENSURE THAT CURTAINS AND ANY OTHER MA-
TERIALS DO NOT OBSTRUCT THE VENTILATION
CONDITION TO PREVENT RISK OF ELECTRIC SHOCK
OR FIRE HAZARD DUE TO OVERHEATING.
Use of batteries ]
oAlign the poles (+ and -) properly when inserting the batteries.
oDo not mix old and new batteries, or batteries of different types
(manganese and alkaline, etc.).
oNever subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
elf the remote control is not to be used for a long pedod of time,
remove the batteries and store them in a cool, dark place.
oDo not attempt to recharge alkaline or manganese batteries.
oDe not use rechargeable type batteries.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid cantacts and may cause a fire.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any
part of your body.
l
I)
m
DANGER LhSERRADIATION_EN OPEN
AVOID[IIRECTEXFOSURETO8FJ_M
DANGER P_D_TIONIJ_SERLOeSC41EOIIVEET
_TER TOtJTE_PO_TIONAUFAISCEkU
AOV_SEL _UOE_ffie30N _C_UOS_nEL_FORSr_G
MARO! kVAIT;_SSkJAStJ(_L_LtJ_ITL_O¢_ffTTAESS_OtETALTTI_k
L_SEF_IE]LYLLEAL_KkTSOSAIEES[EN
LAS_RSTRk[NI_3_ _N_ _EL_ _IpP_O_H
VARNING Sp_REN_tJfiKOPpL_Dfi_TP_KTAEJSTR_LEN
_E_ST_G _ OEKSfLk_S OG$i_E_SL_S
ADVkffSEL B_YIESL_Nf_k[KSPO_R_NGFO_STP_t_N
VORSICHT LASEP3TR,_LU__NN_BOECK_NGOE_FFNE[
NIGHTO_MST_N__JSSETZEN
(Inside ofproduct)
tl_lt_rieur de I*ap,pareil)
(Indersidenat apparatet)
(Tuotteensis_ll_)
(Apparatens insida)
(Produktets innside)
(IraInneren des Ger_tes)
(Back of product)
I AUTION:
The AC voltage is different according to the area.
Be sure to set the proper voltage in your area before use.
(For details, please refer to page g.)
Transmission
window
About 7 meters in front of the
signal sensor
I Operation notes I
• Do not place obstacles between the remote control signal sensor
and remote control unit.
oDo not expose the remote control signal sensor to direct sunlight or
to the bright light of an invertor fluorescent light.
eTake care to keep the remote control signal sensor and end of the
remote control unit free from dust.
elf this system is installed in a rack with glass doors, the glass doors'
thickness or color might make it necessary to use the remote con-
trol a shorter distance from the system.
I To prevent damage
eNever placeheavy items ontop of the unit.
oDo notdisassembleor reconstructthe unit.
eOo notspillwateror otherliquidsintothe unit.
RQTS067
To Next Page
Loading...
