Panasonic SC-DT310 User Manual (English)

Questions and Answers:

R
Robert MillerAug 14, 2025
How to fix picture distortion on my Panasonic SC-DT310?
- J
  Joanna MurrayAug 14, 2025
  If you're experiencing a distorted picture or no picture on your Panasonic Stereo System, start by checking the connection to your television and ensuring that the TV is turned on and set to the correct video input. Also, verify the "TV Aspect" setting in the SETUP menus under Video to match your television. If connected through a video cassette recorder, connect directly to the television instead. You can also try changing the size with the variable zoom function and checking the settings in the GUI screen’s Picture menu. If you are using an indoor antenna, change to an outdoor antenna. The television antenna wire is too close to the unit. Change the zoom ratio to 'k1.00'. With the GUI screen, change 'Subtitle Position' to '0'. With the GUI screen, change '4:3 Aspect' to 'Normal'.
C
codydownsAug 18, 2025
How to reduce noise on my Panasonic Stereo System?
- J
  Joseph Michael DDSAug 18, 2025
  If you're experiencing noise, distorted sound, or difficulty tuning into AM frequencies with your Panasonic Stereo System, try adjusting the position of the FM or AM antenna, or use an outdoor antenna. For AM broadcasts, press [SETUP] and select 'MODE A' or 'MODE B'. Also, move the antenna away from other cables and cords, and move the television away from the unit. You can change the frequency step by pressing [SELECT] to select 'AM', then press and hold [SELECT] for 10 seconds.
B
Brian BatesAug 21, 2025
Why is there no sound coming from my Panasonic SC-DT310?
- B
  Brandon PerezAug 21, 2025
  If your Panasonic Stereo System isn't producing any sound, start by checking the basics: increase the volume and ensure muting is turned off. If that doesn't work, try switching the unit off and then back on to see if it resolves the issue. Also, shorting of speaker wires or using speakers with lower impedance than the unit's rating can cause this problem.
T
Tina GloverAug 25, 2025
Why am I hearing humming or no subwoofer sound from my Panasonic SC-DT310?
- N
  Nicole VaughnAug 25, 2025
  If you are hearing humming during play or no sound from the subwoofer on your Panasonic Stereo System, it might be due to an AC mains lead or fluorescent light being near the cables. Try moving them away. Also, ensure that the subwoofer hasn't been set to 'SUB W OFF'.
D
Denise WallaceAug 27, 2025
How to troubleshoot no power on my Panasonic SC-DT310 Stereo System?
- M
  Michael BarreraAug 27, 2025
  If your Panasonic Stereo System isn't powering on, ensure the AC mains lead is securely inserted into the household mains socket. The unit may have been switched to standby by the sleep timer.
B
Brian OrtizAug 30, 2025
What does it mean if my Panasonic Stereo System displays 'NO DISC' or 'ERROR'?
- S
  Shawn PerezAug 30, 2025
  If your Panasonic Stereo System's display is off, press [FL DISPLAY] to turn it on. If you see "NO PLAY" or "NO DISC", ensure you've inserted a disc that the unit can play and that it's inserted correctly, or that you haven't inserted a blank DVD-RAM. If you see “F61”, “DVD U11” or “ERROR”, and the unit powers down, it might be due to an audio cable issue or speaker cable short. If the problem persists after turning the power back on, consult your dealer. If the disc is dirty, wipe it clean. If you see “DVD H??” it depends on the status of the unit. Try resetting the unit by pressing the power button to standby and then back on, or disconnecting and reconnecting the AC mains lead. If the service numbers fail to clear, contact a qualified service person.
A
Amanda RiveraSep 3, 2025
How to turn on the on-screen display on my Panasonic SC-DT310?
- A
  Amy HillSep 3, 2025
  Go to Display in the SETUP menus of your Panasonic Stereo System, and select 'On' for 'On-Screen Messages'.
N
Nicholas RobinsonSep 6, 2025
What to do if GUI screens are not fully displayed on my Panasonic SC-DT310?
- M
  Melissa ReedSep 6, 2025
  Press [3, 4] while the rightmost icon is highlighted to move the GUI screens down on your Panasonic Stereo System.
D
David VazquezSep 9, 2025
How do I change the disc menu language on my Panasonic SC-DT310?
- T
  Timothy WalkerSep 10, 2025
  Go to Disc in the SETUP menus of your Panasonic Stereo System, and select the preferred language for 'Menus'.

AV CONTROL RECEIVER

Amplifier Section

RMS power output (FRONT)	2 x 60 W
RMS power output (SURROUND)	2 x 60 W
RMS power output (CENTER)	60 W
RMS power output (SUBWOOFER)	100 W
DIN power output (FRONT)	2 x 48 W
DIN power output (SURROUND)	2 x 48 W
DIN power output (CENTER)	48 W
DIN power output (SUBWOOFER)	80 W
Load impedance (FRONT, SURROUND, CENTER)	6 ≠
Load impedance (SUBWOOFER)	3 ≠

FM Tuner Section

Frequency range	87.50–108.00 MHz
Antenna terminals	75 ≠ (unbalanced)

AM Tuner Section

Frequency range	522–1629 kHz
Frequency range (Southeast Asia)	520–1630 kHz

General

Power supply (UK, Australia, N.Z.)	AC 230–240 V, 50 Hz
Power supply (Continental Europe, Russia)	AC 230 V, 50 Hz
Power supply (Southeast Asia)	AC 220–240 V, 50/60 Hz
Power consumption	60 W
Standby condition	0.7 W
Dimensions	197 x 70.9 x 368 mm
Mass	2.5 kg

DVD/CD PLAYER

Audio

Number of channels	5.1 (FL, FR, SL, SR, C, SW)

Video

Signal system	PAL, PAL60/NTSC
Output terminal	RCA terminal (composite video)

Pickup

Beam source	Semiconductor laser
Wavelength	658/790 nm

FRONT SPEAKER

Speaker Specifications

Type	2 way, 2 speaker, Closed
Woofer	12 cm cone type
Tweeter	2.5 cm semi-dome type
Impedance	6 ≠
Input power	60 W (Music)
Sound pressure level	81 dB/W (1.0 m)
Crossover frequency	4.5 kHz
Frequency range	40 Hz–50 kHz (j16 dB)

Weight and Dimensions

Dimensions	161 x 289 x 283 mm
Mass	3.3 kg

CENTER, SURROUND SPEAKER

Speaker Specifications

Type	1 way, 1 speaker, Bass reflex
Woofer	6.5 cm cone type
Impedance	6 ≠
Input power	60 W (Music)
Sound pressure level	79 dB/W (1.0 m)
Frequency range	110 Hz–25 kHz (j16 dB)

Weight and Dimensions

Dimensions (CENTER)	126 x 123 x 121 mm
Dimensions (SURROUND)	90 x 140 x 121 mm
Mass	0.8 kg

SUBWOOFER

Speaker Specifications

Type	1 way, 1 speaker, Bass reflex
Woofer	17 cm cone type
Impedance	3 ≠
Input power	100 W (Music)
Sound pressure level	80 dB/W (1.0 m)
Frequency range	43 Hz–500 Hz (j16 dB)

Weight and Dimensions