External unit
Enjoying audio from iPod or iPhone
g Inserting an iPod/iPhone
Press [;, iPod] to open the sliding door.
Insert the suitable dock adapter (not included) for the
iPod/iPhone.
Press [;, iPod] to close the sliding door.
g Removing an iPod/iPhone
Repeat step and (➡ left).
To remove, simply pull the iPod/iPhone straight out to
disconnect it.
Repeat step and (➡ left).
If the iPod/iPhone dock is not tilted when connecting or
disconnecting the iPod/iPhone, it may cause damage to the
connector.
When inserting an iPod/iPhone into the unit, be sure to use
the dock adapter either supplied with the iPod/iPhone or
commercially available from Apple Inc.
Reduce the volume of the main unit to minimum before
connecting or disconnecting the iPod/iPhone.
•
•
•
Connect the iPod/iPhone
(not included) firmly.
Be sure to remove the iPod/iPhone
from its case.
Push the docking switch
lever back until it clicks
into place.
Push!
Click!
Press [;] to unlock the
iPod/iPhone dock and
then pull the docking
switch lever to tilt the
iPod/iPhone dock.
Click!
Dock adapter
Lever
Connector
Clips
Insert the side of the
iPod/iPhone dock
adapter with the
clips facing towards
you first and then
push the opposite
side until it clicks
into place.
[;]
Notes on iPhone:
All phone features can only be controlled by the iPhone’s
touch screen.
The unit does not display incoming calls or the phone status.
The ringtone of incoming call can be heard from the iPhone’s
speaker. When the unit is in iPod/iPhone mode, the ringtone
can also be heard from the unit’s speakers.
Connecting or disconnecting the iPhone from the unit will not
cancel a call.
There is no Apple Inc. specification that will guarantee the
iPhone responses above. iPhone responses may vary on
new iPhone models or iPhone new software updates.
•
•
•
•
•
Play
Press [iPod q/h].
Pause
Press [iPod q/h] or [g].
Skip track
Press [u/t] or [y/i].
Search the current
track
Press and hold [u/t] or
[y/i].
Display iPod/iPhone
menu/return to previous
menu
Press [iPod MENU] in the play
mode.
(Remote control only)
Select contents from
iPod/iPhone menu
Press [e,r] and then [OK].
(Remote control only)
■ Charging the iPod/iPhone
When iPod/iPhone is being charged in standby mode,
“IPOD CHARGING” is shown on the main unit’s display.
Check iPod/iPhone to see if the battery is fully charged. If you
are not using iPod/iPhone for an extended period of time after
recharging has completed, disconnect it from the main unit as
the battery will be depleted naturally. (Once fully recharged,
additional recharging will not occur.)
•
•
To Next Page
Loading...
