Panasonic SC-HC400

10
TQBJ2049

≥ To use this unit’s remote control with a Bluetooth
®
device, the
Bluetooth
®
device must support AVRCP (Audio Video
Remote Control Profile).
Depending on the status of the device, some controls may
not work.
≥ [CD], [USB]: Tracks can be selected by pressing the numeric
buttons.
≥ Maximum number of displayable characters:
Approx. 32
≥ This system supports ver. 1 and 2 ID3 tags.
≥ Text data that is not supported will not be displayed or will be
shown differently.
Select the playback mode.
1 Press [PLAY MENU] repeatedly to select
“PLAYMODE” or “REPEAT”.
2 Press [2, 1] to select the setting and then press
[OK].

≥ During random playback, you cannot skip to tracks which
have been played or press the numeric buttons.
≥ Playmode function does not work with “Program play”.
≥ The mode is canceled when you open the sliding door or
remove the USB device.
This function allows you to program up to 24 tracks.
[CD] (CD-DA)
1 Press [PROGRAM] in the stop mode.
≥ “PROGRAM” is shown for a few seconds.
2 Press the numeric buttons to select the desired
track.
≥ Do this step again to program other tracks.
3 Press [1/;] to start playback.
[CD] (MP3), [USB]
1 Press [PROGRAM] in the stop mode.
≥ “PROGRAM” is shown for a few seconds.
2 Press [3, 4] to select the desired album.
3 Press [9] and then press the numeric buttons to
select the desired track.
4 Press [OK].
≥ Do steps 2 through 4 again to program other tracks.
5 Press [1/;] to start playback.

≥ The program memory is cleared when you open the sliding
door or remove the USB device.
Playback modes ([CD], [USB])
PLAYMODE
OFF
PLAYMODE
Cancels the play mode setting.
1-TRACK Only plays the selected track.
≥ “1”, “ ” is displayed.
(Skip to the desired track.)
1-ALBUM Only plays the selected album.
≥ Press [3] or [4] to select the album.
≥ “1”, “ ” is displayed.
RANDOM Plays the contents randomly.
≥ “RND” is displayed.
1-ALBUM
RANDOM
Plays the tracks in the selected
album randomly.
≥ Press [3] or [4] to select the album.
≥ “1”, “ ”, “RND” is displayed.
REPEAT
ON REPEAT Turns on repeat mode.
≥ “`” is displayed.
OFF
REPEAT
Turns off repeat mode.
Program play
(
[CD], [USB])
Check
program
contents
Press [:] or [9] in the stop
mode.
Clear the last
track
Press [DEL] in the stop mode.
Cancel
program
mode
Press [PROGRAM] in the stop mode.
≥ “PGM OFF” is shown for a few seconds.
Clear all
programed
tracks
Press [ ∫ ] in the stop mode. “CLEAR
ALL” is shown. Within 5 seconds, press
[ ∫ ] again.
SC-HC400PC.book 10 ページ ２０１７年３月１４日 火曜日 午後１時１９分