6
TQBJ2049
Connections
≥ Tape the antenna to a wall or column in a position with the least amount of interference.
≥ If radio reception is poor, use an outdoor antenna (not supplied).
1 Connect an external music device using an audio
cable (not supplied).
≥ Plug type: ‰3.5 mm (
1
/
8
q
)
stereo
2 Press [RADIO, EXT-IN] repeatedly to select “AUX”
and start playback on the connected device.
∫ To select the sound input level of the
external device
1 While in AUX mode, press [SOUND] repeatedly to
select “INPUT LEVEL”.
2 Press [2, 1] to select “NORMAL” or “HIGH” and
then press [OK].
≥ The factory default is “NORMAL”.
≥ To improve sound distortion when “HIGH” is selected, select “NORMAL”.
≥ Switch the equalizer off or turn the volume of the external device down to reduce the input signal. High level of input signal will
distort the sound.
≥ For details, refer to the operating instructions of the device.
Connect an external music device
Connect the antenna.
To an AC outlet
Connect the AC power supply cord after all other connections are completed.
This unit consumes a small amount of AC power (l 17) even when turned off.
≥ In the interest of energy conservation, if you will not be using this unit for an extended period of time, unplug it from
the AC outlet.
≥ Some settings will be lost after you disconnect the system. You have to set them again.
Adhesive tape
(not supplied)
FM indoor antenna
(supplied)
AC power supply cord (supplied)
Audio cable
(not supplied)
SC-HC400PC.book 6 ページ ２０１７年３月１４日 火曜日 午後１時１９分
To Next Page
Loading...
