16
RQT9709
You can preset up to 20 DAB/DAB+ stations.
Preparation
≥ Press [RADIO] repeatedly to select “DAB/DAB+”.
1 While listening to a DAB broadcast
Press [OK].
2 Press [3, 4] to select the desired preset channel
number and then press [OK].
≥ You cannot preset stations when the station is not
broadcasting or when the secondary service is selected.
≥ The station occupying a channel is erased if another station
is preset in that channel.
∫ Listening to preset DAB/DAB+ stations
Preparation*
1
1 Press [RADIO] to select “DAB/DAB+”.
2 Press [PLAY MENU] repeatedly to select
“TUNEMODE” and then press [OK].
3 Press [3, 4] to select “PRESET” and then press
[OK].
1 Press [RADIO] to select “DAB/DAB+”.
2 Press [:/6] or [5/9] to select the
station.
≥ To select by preset, make sure that stations have already
been preset manually.
≥ To add additional preset stations, select the station using the
method mentioned in “Listening to the memorised stations”
(> 15).
Some DAB/DAB+ stations provide a secondary service
as well as the primary service. If the station you are
listening to is providing secondary service, “ ” will be
displayed.
1 While “ ” is displayed.
Press [PLAY MENU] repeatedly to select
“DAB SECONDARY” and then press [OK].
2 Press [3, 4] to select the secondary service and
press [OK].
The setting will go back to primary service when changes are
made (e.g. the station is changed).
Press [DISPLAY] to change the display.
The information will scroll through the display.
Each time you press the button:
If the DAB broadcast includes time information, this
unit’s clock will be automatically updated.
1 Press [PLAY MENU] repeatedly to select “AUTO
CLOCK ADJ” and then press [OK].
2 Press [3, 4] to select “ON ADJUST” and then
press [OK].
Select “OFF ADJUST” to turn the automatic clock adjustment
function off.
To check the signal reception quality, at least 1
frequency block needs to be successfully memorised.
≥ If “SCAN FAILED” is displayed after “DAB/DAB+” is
selected or after an auto scan, proceed to “Manually
tuning 1 frequency block” (> below)
≥ If stations have already been memorised to this unit,
proceed to “Checking the DAB/DAB+ signal
reception quality” (> 17)
∫ Manually tuning 1 frequency block
Use this function to scan 1 frequency block after
adjusting the position of the DAB antenna.
Preparation
Note down a frequency block that can be received in
your region (e.g., 12B 225.648 MHz).
1 While “SCAN FAILED” is displayed.
Adjust the position of the DAB antenna.
2 Press [PLAY MENU] repeatedly to select
“TUNEMODE” and then press [OK].
3 Press [3, 4] to select “MANUAL” and then press
[OK].*
1
4 Press [3, 4] to select the frequency block that is
receivable in your region and then press [OK].
*1: The “TUNEMODE” setting is memorised until it is changed.
Presetting DAB/DAB+ stations
Listening to the secondary
service
Display
Dynamic label: Information about the broadcast
PTY display: Programme type
Ensemble label: The name of the ensemble
Frequency display: The frequency block and
frequency is displayed.
Time display
Automatic clock adjustment
To verify or improve the
signal reception quality
SC-HC57DB~RQT9709-1B.book Page 16 Friday, March 2, 2012 3:31 PM
To Next Page
Loading...
Need help?
General
