Panasonic SC-HT65

6
RQTV0225
SUB
WO
OFER
6
Lch
SURROUND
Lch
SURROUND
3
3
SUBWOOFER
FRONT (R)
FRONT (L
)
CENTER
Push!
+: White
−: Blue
SURROUND (L
)
SURROUND (R
)
Speaker setup
STEP 1
Speaker setup
+: White
−: Blu
e
Push!
1
+: White
−: Blu
e
Push!
1
2
2
Preventing the speakers from falling over
Obtain the screws appropriate to the walls and pillars to which they are going to
be fastened.
Consult with a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not have
strong enough support. Improper attachment may result in damage to the wall
or speakers.
•
•
Screw eye
(not included)
Wall
1
3
2
String (not included)
Thread from the wall
to the speaker and
tie tightly.
You can remove and use the
cable from the stand. To reattach
the cable (➡ page 10).
Leave about 100 mm.
Insert the wire fully.
Press into the groove.
Tighten securely.
■
Speaker assembly option
Approx.
150 mm
+: White
−: Blu
e
Push!
2
2
1
2
Position the
cable between
the ridges.
Leave about 80 mm.
3
4
5
Insert the wire fully.
Press into the groove.
Tighten securely.
Attach the speaker-cable stickers to make connection easier.
Speaker-cable sticker (included)
Do not insert the
wires beyond the
wire insulation.
Be careful not to cross
(short-circuit) or reverse the
polarity of the speaker wires
as doing so may damage the
speakers.
Connect the speakers to the receiver
Thread the speaker cable
through the base.
Attach the
speaker.
SC-HT65 GN-En.indb 6 8/17/2007 4:19:55 PM