Enhancing the surround sound
effect: Surround
Enhancing the sound from the
center speaker: Center Focus
Enhancing the stereo sound:
Dolby Pro Logic
II
You can refine the sound quality to suit the placement of
your speakers when listening to stereo sources.
Press [FI MODE].
BI-AMP TS:
ON: The amplifiers for the front and surround
speakers separately run the low frequency and
mid to high frequency. This reduces distortions and
produce a more open and cleaner sound. Use this
mode when surround speakers are stacked up (
➡
Speaker installation options, page 7) or placed
beside front speakers.
OFF : Cancel
SUBWOOFER:
ON (-5 to +5)
OFF: Cancel (When Bi-Amp TS is off, this is only
available for 2-channel sources.)
CENTER: Adjustable only when Bi-Amp TS is on.
ON (-5 to +5)
OFF: Cancel
PARTY: Adjustable only when Bi-Amp TS is off.
STEREO: Front and surround speakers produce
stereo source.
MONO: Center, front and surround speakers
produce same sound source.
OFF: Cancel
–
Sound field and sound quality
Sound field and sound quality
MANUAL EQ
e
,
r
CH SELECT,
-TEST
C.FOCUS,
%
PL
II
MANUAL
EQ, SOUND
SOUND
SRND
e
,
r
,
w
,
q
,
ENTER
FI MODE
The following sound effects may not be available or
have no effect depending on the type of source, or
when headphones are used.
•
Changing the sound quality:
Sound
Press [SOUND].
PRESET EQ
Create your own sound quality effects.
Press [MANUAL EQ].
BASS (-3 to +3)
MID (-3 to +3)
TREBLE (-3 to +3)
After you select a setting, press [
w
,
q
] to switch
between the sound range.
The changes you make are stored and automatically
recalled the next time you select “MANUAL EQ”.
•
Using the Manual Equalizer:
Manual EQ
Refining the sound quality:
Fi Mode
Note
H.BASS
ON: You can enhance low-frequency sound so that
heavy bass sound can be heard clearly, even if the
acoustics of your room are not optimal.
OFF: Cancel
HEAVY : Adds punch to rock.
CLEAR : Clarifies higher sounds.
SOFT : For background music.
EQ-OFF : Cancel (no effect is added).
To Next Page
Loading...
