Panasonic SC-PT90

9
RQTX1198
Getting Started
≥Language
Select the language used on menu screen.
≥TV aspect
Select the aspect to suit your TV.
≥Speaker layout
Select “Surround layout (Recommended)” mode or
“Front layout (Alternative)” mode according to your
speaker layout (B 6, Installation).
≥Speaker check
Listen to speaker output to confirm speaker
connections.
≥Speaker output
Make surround sound setting for speaker output.
≥TV audio
Select the audio input connection from your TV.
For AUX connection (B 8): Select “AUX”.
For HDMI connection (B 7): Select “ARC”.
For SCART (AV) connection (B 7): Select “AV”.
This will be the TV audio setting for VIERA Link
“HDAVI Control”. (B 16)
[Note]
≥If this unit is connected to a “HDAVI Control 3 or later”
compatible TV via HDMI cable, the menu language
and TV aspect information will be retrieved via VIERA
Link.
≥If this unit is connected to a “HDAVI Control 2”
compatible TV via HDMI cable, the menu language
information will be retrieved via VIERA Link.
≥Settings in the EASY SETUP can also be changed in
the player settings (e.g. language, TV aspect, TV
audio (B 17)).
Up to 30 stations can be set.
≥“SET OK” is displayed when the stations are set, and
the radio tunes to the last preset station.
≥“ERROR” is displayed when automatic presetting is
unsuccessful. Preset the stations manually (B right).
≥The FM setting is also shown on the TV display.
Press and hold [PLAY MODE] to display “MONO”.
To cancel the mode, press and hold the button again
until “AUTO ST” is displayed.
≥The mode is also cancelled when you change the
frequency.
Up to 30 stations can be set.
A station previously stored is overwritten when another
station is stored in the same channel preset.
EASY SETUP settings
Listening to the radio
Presetting stations automatically
1
Press [RADIO] to select “FM”.
2
Press [MENU].
Each time you press the button:
LOWEST (factory preset):
To begin auto preset with the lowest frequency.
CURRENT:
To begin auto preset with the current frequency.
§
§ To change the frequency, refer to “Manual tuning”
(B right).
3
Press and hold [OK].
Release the button when “FM AUTO” is displayed.
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Listening/confirming the preset channels
1
Press [RADIO] to select “FM”.
2
Press the numbered buttons to select a channel.
≥To select a 2-digit number
e.g. 12: [S10] B [1] B [2]
Alternatively, press [X, W].
If noise is excessive
Manual tuning
1
Press [RADIO] to select “FM”.
2
Press [SEARCH6, SEARCH5] to select the
frequency.
≥To start automatic tuning, press and hold
[SEARCH6, SEARCH5] until the frequency
starts scrolling. Tuning stops when a station is
found.
Presetting stations manually
1 While listening to the radio broadcast
Press [OK].
2 While the frequency is flashing on the display
Press the numbered buttons to select a channel.
≥To select a 2-digit number
e.g. 12: [S10] B [1] B [2]
Alternatively, press [X, W], and then press [OK].
QUICK START GUIDEQUICK START GUIDEQUICK START GUIDE
steps 2–5
SC-PT90EB-RQTX1198-B_eng.book Page 9 Wednesday, May 5, 2010 11:58 AM