11
RQT0B31
Memory presetting
You can preset up to 30 FM stations.
█ Automatic presetting
1 Press [AUTO PRESET] to select “LOWEST” or
“CURRENT”.
2 Press [OK] to start presetting.
The tuner presets all the stations it can receive into
the channels in ascending order.
To cancel, press [8].
█ Manual presetting
1 Press [3] or [5] (unit: [2/3] or
[5/6]) to tune in to the station.
2 Press [OK].
3 Press the numeric buttons to select a preset
number.
Re-do steps 1 through 3 to preset more stations.
The new station replaces any station that occupies
the same preset number.
█ Selecting a preset station
Press the numeric buttons, [2] or [6] to select
the preset station.
Using the unit
1 Touch [8] to select “PRESET”.
2 Touch [2/3] or [5/6] to select the preset
station.
Improving the sound quality
1 Press [PLAY MENU] to select “FM MODE”.
2 Press [Y, U] to select “MONO” and then press
[OK].
To cancel, select “STEREO”.
“MONO” is also canceled when you change the
frequency.
To memorize the setting
Continue with step two of “Manual presetting”.
Checking the signal status
Press [DISPLAY].
FM allocation setting
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1 Press [RADIO/EXT-IN] to select “FM”.
2 Touch and hold [SELECT] on the unit.
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, re-do the above steps.
• Preset frequencies are erased after you change the
setting.
Sound effects
1 Press [EQ] to select the sound effect.
2 Press [Y, U] (unit: [<, >]) to select the setting and
then press [OK].
D.Bass
1 Press [D.BASS] to select “D.BASS LEVEL” or
“D.BASS BEAT”.
To cancel, select “OFF D.BASS”.
2 Press [Y, U] (unit: [<, >]) to select the setting and
then press [OK].
Note:
D.BASS BEAT: This function emphasizes the attack level of
the drumbeat and produces a punchy sound. Depending on
the track, the effect may be small.
Illumination
You can turn on or turn off the illumination on the system.
Press [ILLUMINATION] to select “ON” and then press
[OK].
To cancel, select “OFF”.
LOWEST Tuning begins from the lowest frequency.
CURRENT
Tuning begins at the current frequency.
FM – – – – The FM signal is weak.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO “MONO” is selected as the “FM MODE”.
The FM signal is in monaural.
PRESET EQ Select the desired preset EQ
setting.
Note:
Select “VOICE EX” for voices to be
heard as if they are coming from a
TV. (The unit and the TV must be put
side by side.)
BASS/MID/TREBLE –4 to +4
SURROUND “ON SURROUND” or
“OFF SURROUND”
SC-UA7 PC RQT0B31-C En.fm Page 11 Thursday, June 9, 2016 9:45 AM
To Next Page
Loading...
