37
LSQT1555
This unit will resume recording/pause mode
about 0.8 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
60% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
¬Rotate the mode dial to select or
.
1 Select the menu. (l 22)
2 Close the LCD monitor while the
mode dial is set to or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause approx. 0.8 seconds
after it is turned on.
To cancel Quick start
Select [SETUP] # [QUICK START] # [OFF]
≥ The default setting is on.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jthe mode dial is switched
jthe battery is removed or the AC adaptor is
disconnected
≥
In the quick start mode it may take some time for
automatic white balance to adjust, if the scene
being recorded has a light source different from
the scene last recorded. (When the colour night
view function is used, however, the white
balance of the scene last recorded is retained.)
≥
In the quick start mode, the zoom magnification
becomes 1
k
and the picture size may differ from
what it was before quick start standby mode.
≥ If [ECONOMY] (l 23) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and then
open it again.
Reduces the image shaking (jitter) due to hand
movement when recording.
¬
Rotate the mode dial to select
or
.
Press the O.I.S. button.
O.I.S.: Optical Image Stabilizer
The image stabilizer icon [ ] appears.
To cancel the optical image stabilizer function
Press the O.I.S. button again.
≥ The default setting is on.
≥
Set the intelligent auto mode to off before turning
the optical image stabilizer function to off.
≥ When a tripod is used, we recommend that you
turn the image stabilizer off.
≥ In the following cases, the image stabilizer
function may not work effectively.
jWhen the digital zoom is used
jWhen the unit is shaken greatly
jWhen you record a moving subject while
tracking it
Quick start
[SETUP] # [QUICK START] # [ON]
Optical image stabilizer
function
O.I.S.
SDR-H81EB-LSQT1555_mst.book 37 ページ ２００９年１月６日 火曜日 午後４時２８分
To Next Page
Loading...
