12
VQT2L26 (ENG)
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is connected to an electrical outlet.
≥ The battery will not be charged if the power is turned on.
1 Connect the AC adaptor to this unit’s DC input terminal.
2 Connect the AC cable to the AC adaptor, then the AC outlet.
≥ For the AC cable, plug in 2 and then 3.
≥ The status indicator will flash red at an interval of 2 seconds, indicating that charging has
begun.
∫ Connecting to the AC outlet
If you turn on this unit while charging the battery using the AC adaptor, you can use the
power supplied from the AC outlet to power the unit for use.
≥ We recommend using Panasonic batteries (l 7, 13).
≥ If you use other batteries, we cannot guarantee the quality of this product.
≥ Do not heat or expose to flame.
≥ Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period
of time with doors and windows closed.
Charging the battery
When this unit is purchased, the battery is not charged. Charge the battery before
using this unit.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
SDRS50&T50&H85EP-VQT2L26_mst.book 12 ページ ２００９年１２月２０日 日曜日 午前１１時１分
To Next Page
Loading...
