Panasonic SH-FX65P

9.2. Service Mode Table (Wireless)
By pressing various button combinations on the player and remote control unit, you can activate the various service modes for
checking.
9.2.1. Service Mode Table 1
FL Display
Key Operation
Front Key
Item
DescriptionMode Name
ID Setting
After 10 seconds.
Active
Transmitter
Type Display
To cancel, press the same
buttons.
(Display 1)
(Display 1)
(Condition 1 - Transmitter is Type A)
(Display 2)
(Display 3)
(Display 2)
(Display 3)
After 2 seconds.
Main room is in CD/DVD
mode.
Main room is in CD/DVD
mode.
Press and hold [FAST
FORWARD] button on the
main unit, and [3] button
on the remote control unit.
Press and hold [SECOND
SELECTOR] button on the
remote control unit.
To set the ID in the Tx & Rx. The
system goes into "Pairing Mode".
[P] will be displayed for 60 seconds to
indicate it is in "Pairing Mode".
During this condition, the "ID set"
button on the receiver unit can be
pressed to pair the Tx & Rx.
After 60 seconds, the FL display will
return to its previous display.
FL Display sequence:
Display 1 2 3.
Note: Carry out pairing when Tx or Rx
has been changed.
To check the type of transmitter
inserted into the main unit. There are
two types of transmitter card. (Type A
& Type B).
Type A: FX65/FX66/Wireless Active
Woofer
Type B: FX85 (For multiroom features)
In normal condition,with transmitter
operating properly and slotted in the
main unit, it shows on FL Display in
Condition 1.
FL Display sequence:
Display 1 2 3.
21
SH-FX65P / SH-FX65PC