Panasonic SH-FX65P

(All schematic diagrams may be modified at any time with
the development of new technology)
Notes:
S1000: ID SET switch.
S1001: POWER switch.
· Importance safety notice :
Components identified by
mark have special
characteristics important for safety.
Furthe rmore, special parts which have purposes of fire-
retardant (resistors), high-quality sound (capacitors), low-
noise (resistors), etc. are used.
When replacing any of components, be sure to use only
manufacturer´s specified parts shown in the parts list.
· Capacitor values are in microfarad(µF) unless specified
otherwise, F=Farad, pF=Pico-Farad
Resistance values are in ohm(Ω), unless specified
otherwise, 1K=1,000Ω, 1M=1,000KΩ
· Voltage and Signal lines:
: +B Signal line
: -B Signal line
: Main signal line
: RF signal line
Special Note :
· This model uses Switching Mode Power Supply (SMPS) for
providing necessary voltages.
· There is no schematic drawings included in this document
for the SMPS Module.
· It is advisable to replace the SMPS module as an assembly
unit.
15 Notes of Schematic Diagram
37
SH-FX65P / SH-FX65PC