21
10 The exchange method of PCB for complete control
1 Remove terminal for complete power
•
Lay the cooker on a rubber sheet or similar so as not to
damage the unit; open the outer lid and make the bottom
of the cooker facing upwards (see fi gure on the right).
•
Unplug the power cord.
•
Dismantle the set screw of the outlet cover (×1), take out
the outlet cover and complete outlet and outlet box.
•
Remove the wirings of the power terminal (3 places).
2 Remove screw for body
•
Remove screws for body (×4)
3 Remove the hinge cover
•
Firstly, remove the fixing screw as shown on the right
fi gure. And then inserts a slotted screwdriver in the crack
at the hinge cover and the body.
•
Using slotted screwdriver as a lever and pry the hinge
cover upwards. And separate the hinge cover and the
body.
IP3830_SR-DF101_Eng_19_121224.in章节1:21 章节1:21 2012-12-24 17:19:44
To Next Page
Loading...
